Project

General

Profile

LVDT coils test setup.

Instructions

Outercoil go to the Sub-d 9 (pen number 1 and 6)

Then the innercoil do you place a BNC connector.

You go from a function generator to a bnc connector of the innercoil.
Press the button on Sine and putt the ->Freq to 10.000,000 kHz

Funtiegenerator

And the setting 100.00,00 microseconds.

Thene you go to the outercoil. Go to the Dub-d 9 female and used pen 1&6
and thene you go Gender changer. Then you go to the Sub amp there are 3 channels go out of the sub-d9. So you have BNC ch 1-2-3.

Used ch 3. Cable 3.

Thake the oscilloscoop and used channel 1. Cable number 3 goes in.
The setting of the scoop:

DC1M
5.00 mV
-200 uV

Add picture from clipboard (Maximum size: 244 MB)